EMERGENCY FUNCTION & AUTO-RESTART FUNCTION
ON/OFF
Emergency
button
The emergency button in some
models could be on the right part
of the unit under the front panel.
The shape and position of the emergency button
may vary according to the model, but their
function is the same.
The appliance is preset auto - restart function by
manufacturer.with this function the air conditioner
can keep the selected settings after a blackout or a
voltage drop.
Lift the unit s front panel to reach the emergency
button of the air conditioner
1. if you press the button once ( one beep ), the air
conditioner will work in forced cooling function;
2. if you press the button twice ( two beeps ), the
unit will work in forced heating function.
3. To switch off the unit , you just need to press
the button again ( a single long beep) . After 30
minutes in forced function , the air conditioner
will automatically start working in FEEL mode .
The FEEL function is described in page 13.
If the remote control is lost, proceed as follows:
display PCB
front panel
To deactivate the AUTO-RESTART function ,pro-
ceed as follows:
1. Switch the air conditioner off and plug it off.
2. Press the emergency button meanwhile plug
it in.
3. Keep pressing the emergency button for more
than 10 seconds until you hear four short beeps
from the unit. The AUTO-RESTART function is
off.
To activate the AUTO - RESTART function ,
follow the same procedure until you hear three
short beeps from the unit.
Emergency
button
ON / OFF
POWER
SLEEP
TIMER
RUN
EMERGENCY FUNCTION
AUTO-RESTART FUNCTION
5
Emergency
button
To Next Page
Loading...
Need help?
General
