®
NOTE: To prevent water damage,
make sure the Hub is mounted with its
antenna pointing straight up and that
the Ethernet cable has a "drip loop"
where it enters any building.
See http://ayrstone.com/support
for additional information, hints,
and troubleshooting tips.
7
Troubleshooting
Gateway Hub:
- Ethernet Light does not come on, or Hub
does not appear in router's DHCP table, or
Hub never checks in to AyrMesh.com
- Check all cables between router and Hub
- Ethernet Light comes on, Hub appears in
router's DHCP table, but Hub does not
check in to AyrMesh.com
- Add Hub's MAC address to your
AyrMesh.com account manually
Remote Hub:
- Signal lights do not not come on
- Make sure Hub was initialized by plugging
into router
- Network slow, only bottom (red) signal
light on
- Low signal strength - put Hubs higher and
ensure good line-of-sight between them
- Network slow, all signal lights on
- Hubs may be too close together - re-think
placement of Remote Hubs
Drip Loop
To Next Page
Loading...
Need help?
General
