User Manual
Page 12 of 40
Step 3
Press Simple Connect for two seconds on
HomePlug Y. After you release the button, the
Power LED
will blink. If the Power LED did
not blink, press Simple Connect
again for
two seconds.
Make sure to press Simple Connect
on
HomePlug Y within two minutes after you
press Simple Connect
on HomePlug X.
The LEDs on both devices will switch off and
on twice to signify that they are searching for
another device to pair with.
Note: Do not press Simple Connect for more than 2
seconds
Step 4
To confirm if the connection was established,
check the LEDs. The Power LEDs
and the
Powerline Activity LEDs
on both HomePlugs
are on.
To Next Page
Loading...
Need help?
General
