Aztech WL556E Connecting

A Z T E C H T E C H N O L O G I E S P T E L T D
Aztech WL556E
Portable High-Speed Wireless-N Repeater
Connecting the Aztech WL556E to a Wireless Modem
Supplied by your Internet Service Provider
Please take note that the steps illustrated in this guide is meant to configure the WL556E to repeat the
signal of an existing ISP supplied Wireless Modem that is using the default wireless configuration. If you
have changed the default wireless settings of your ISP supplied Wireless Modem, then you would need
to key-in the new settings that are currently configured in your Wireless Modem.
1. Identify the model of your Wireless Modem and write down its current wireless configuration.
1.1
a. Connect a PC to the wireless modem.
b. Launch your web browser. Type 192.168.1.254 in the address bar.
Press Enter.
c. Click Wireless Settings and take note of the
Network Name, Wireless
Channel, Authentication, and Encryption Key of your Wireless
Modem. Refer to drawing below for default wireless encryption key.
d. After you write down the Wireless Information, proceed to step 2.

Aztech WL556E Specifications

General

Brand	Aztech
Model	WL556E
Category	Repeater
Language	English