AZURO XP03Hs-Capillary - Time and Timer Settings; Running Data Settings

09
(1) Long press“ ”5 seconds to enter operating parameter setting interface.
(2) .You can
check water -in/water-out /Condenser/ambient temperature.
(3) Mode can be changed while running.
(4) When the unit is switched off, current time is displayed.
Time setting:
Press to set the time, and press or to adjust the time
After pressed the again to store the new data.
When setting the time, and can not work.
TIMER ON SETTING
Press to set the time for HP start to run ,and press or to adjust starting time. then,
to press again to store the new data.
When lights, Press to cancel the timer setting.
TIME OFF SETTING
Press to set the time for HP stop running, press or to adjust the time of stop
running. then, press againto store the new data.
When lights, press to cancel the timer setting.
Press and hold for 5 seconds to enter operating parameter setting interface
1
0
1
1
0
0
ATTENTION:
HP running parameters must be checked after installation and before first used.
When HP is running, LED displays water inlet temperature
When HP is stopping, LED wire controller displays the actual time.
When HP running, the running mode ( cooling or heating) and water temp could be changed.
Other parameters only changeable when HP stopping.
!
5.4 RUNNING DATA SETTING