b'Twin Bicycle - Replacing the Batteries

Warning:
- MTB descents should be practised safely.
-
Ensure that the bicycle is suitable for the purpose (descents, cross-country, extreme freeriding...).
- Ensure that the bicycle is in a perfect working order.
- To minimise the risk of accidents: wear a helmet, wear suitable protection, control your bicycle and… be careful!
Front light
A-B-C: Fitting
Pour un serrage optimum privilégier le 1er cran de
l'élastique.
D: Removal
Press the reector (1) to push the light forwards (2).
Replacing the batteries:
When the red wear indicator lights up, change the batteries.
Batteries required: Two 1.5 Volt LR14 alkaline batteries.
To open, press on one of the chrome-plated strips (1) and
open by turning the front of the light (2).
Battery direction is shown on the bulb holder and on the
inner contact.
Some products may be equipped with dierent but similar
lighting.
Replacing the bulbs:
Bulb required: 2.4 Volts 0.5 A Krypton type
H
Fitting lights:
(does not apply to dynamo-type lights)
Compatible
with upright
handlebars.
Diameter:
0,75 in (19 mm) à
1,26 in (32 mm).
Compatible with seat
posts or seat stays.
Diameter: 0,75 in (19 mm) à
1,26 in (32 mm).
M
- 7 -
1
1
Rear light
Assembly
- The rst hole is for tting to the seat post.
- The second hole is for tting to seat stays.
Position the rear light horizontally using the
adjustment wheel.
2
2
STOP