b'Twin Bicycle - Bicycle Position Adjustment Guide; Adjusting Seat Height

Fitting dynamo-type lights
Hub dynamo:
B
efore removing the front wheel, disconnect the dynamo’s electric
cable.
Replacing the bulbs:
B
ulbs required:
• 6 Volt / 2.4 Watt Krypton type bulb for Elops 3 and Elops 5.
• 6 Volt / 2.4 Watt halogen bulb for the b’Twin Pack and Elops 7.
Directions for use:
Refer to the charts appended to the end of these instructions p 23.
Adjusting the seat:
The minimum seat height is the height when the seat is moved down as far as it will go and once the clamp is locked.
Practical information
Depending on the terrain you are travelling on, seat height can be modied:
- On at ground or when climbing, the seat should be in a high position for greater eciency.
- When travelling downhill, the seat should be slightly lowered to improve bicycle control and to
make it easier to get over obstacles.
PLEASE NOTE THE INSERTION LIMIT!
For your safety, the saddle shouldn't be pulled out further than the mark
indicated on the seat post: minimum d’insertion.
For advice on making more precise
adjustments to your bicycle, go to
the b’Twin.com website.
HOW TO ADJUST YOUR POSITION ON THE BICYCLE
Measure your height
Refer to your settings
charts for my bike
Adjust your bicycle
- 8 -
2
1 3
m
a
x
m
ax
m
ax
max
S in (cm) HS in (cm) Hg in (cm)
16"
4,1 - 4,3
(105 - 109)
4,3 - 4,5
(110 - 114)
1,5
(37,5)
4,5 - 4,7
(115 - 120)
1,9
(48,5)
1,9
(49)
1,9
(49,5)
Elops
S
in (cm) HS in (cm) H in (cm)
6,1 - 6,2
(155 - 159)
6,3 - 6,4
(160 - 164)
6,5 - 6,6
(165 - 169)
6,7 - 6,8
(170 - 174)
6,9 - 7
(175 - 179)
2,2
(55,5)
2,3
(58)
2,4
(60)
+ 0,5
(+ 12)
2,5
(62,5)
2,5
(64,5)