Babboe Curve - Step 8.2: Attaching Seat Belts

32
Step 8.2: A aching the seat belts
1. Pull the buckles at the ends of the seat belt through a rubber rectangle from
sachet N (see detail picture Y). Then pull the buckles through the the holes in
the rear panel, as illustrated in detail picture Z.
2. Then turn the buckles 90
o
so they are posi oned as illustrated in detail picture
AA. The seat belt is now fi rmly and securely in place.
3. Next, a ach the other end of the seat belt to the seat as shown in detail
picture AB.
Important! Adhere to the specifi ed order for nuts, bolts and washers in order
to secure everything in the best possible way.
4. Repeat these steps for the other 3-point seat belts.
36.
Y.
Z.
AA.
AB.
Parts needed:
- 4 sets of 3-point seat belts
- Sachet M (4x M6 bolts, 4x M6 cap nuts, 4x M6 spring washers,
8x M6 washers)
-Sachet N (8x rubber rectangle)
Tools needed:
- Open-end spanner # 10
- Philips screwdriver
!