Clamp-holding system
With the clamp-holder you can easily position
the 3-tooth clamp at any point on the racket by
sliding it over the circular turntable.
During the stringing process, in order to keep
the string pulled, you should:
- slide the clamp-holder over the turntable to
position it under the string that you wish to
keep pulled,
- tighten the string using the locking lever of
the 3-tooth clamp (1),
- fasten the clamp-holder onto the turntable
by pushing down the locking handle (2).
To release the clamp-holder, loosen the
string by lifting the locking lever and let the
clamp drop. You can also release the clamp-
holder by lifting the locking handle. To make
it easier to move, hold it by the base of the
clamp support barrel.
♦ Removing the racket
Always start by loosening the billiards before opening the arms. After releasing the racket,
unscrew the billiards completely so that you can easily insert the next racket.
♦ Turntable braking system
The locking button on the circular turntable can be used to immobilise it during rotation. You
will find this function useful when tightening the knots and tidying up the strings after you
have finished stringing.
25
2
1
To Next Page
Loading...
