Replacing the Presser Foot 41
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Adjusting the pressure of the
presser foot
The presser foot pressure (the amount of pressure
applied to the fabric by the presser foot) can be
adjusted. For best results, increase the pressure when
sewing thin fabrics, and decrease the pressure when
sewing thick fabrics.
a
Lower the presser foot lever.
a Presser foot lever
b
Turn the presser foot pressure dial at the back
of the machine to adjust the pressure of the
presser foot.
The presser foot pressure can be set to one of
four levels (between 1 and 4). The larger the
setting, the stronger the pressure. Use setting 1
or 2 for thick fabrics, use setting 3 or 4 for
thinner fabrics.
a Strong
b Weak
c
When you are finished sewing, reset the dial to
3 (standard).
Removing the presser foot
holder
Remove the presser foot holder when cleaning the
sewing machine or when installing a presser foot that
does not use the presser foot holder, such as the
quilting foot. Use the screwdriver to remove the
presser foot holder.
■ Removing the presser foot holder
a
Remove the presser foot.
• For details, refer to “Replacing the presser
foot” (page 39).
b
Use the screwdriver to loosen the presser foot
holder screw.
a Screwdriver
b Presser foot holder
c Presser foot holder screw
■ Attaching the presser foot holder
a
Align the presser foot holder with the lower-
left side of the presser bar.
b
Hold the presser foot holder in place with your
right hand, and then tighten the screw using
the screwdriver in your left hand.
a Screwdriver
To Next Page
Loading...
Need help?
General
