Sewing the Various Built-In Decorative Patterns 125
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3
e
Press (OK key) or (Cancel/clear
key).
X The initial stitch screen appears again, and
the stitching density is changed.
Changing the pattern length
The length of one part of a satin stitch can be set to
one of five sizes.
a
Select a satin stitch (No. 41–56 of ,
selected with ).
b
Press (Settings key) in the operation
panel.
X The settings screen appears.
c
Press or (Stitch length keys) until
is displayed.
X The screen for changing the length of a satin
stitch appears.
d
Press or (Stitch width keys) until the
desired ratio is selected.
The length can be set within the range of
and .
• Press to reduce the length. If the key is
pressed while the smallest setting (×1) is
displayed, a beep sounds.
• Press to increase the length. If the key is
pressed while the largest setting (×5) is
displayed, a beep sounds.
X The satin stitch length is changed.
e
Press (OK key) or (Cancel/clear
key).
X The initial stitch screen appears again.
● If the stitching density is too compacted,
depending on the needle, the stitches may
be bunched together, causing the needle
to break.
To Next Page
Loading...
Need help?
General
