11
Coding Failed
• It’s possible there’s interferance on the specic channel, try changing
the channel on the LCD MONITOR by pushing the (UP) Arrow.
• The Unit might be too far away. Attempt to plug in the camera closer
to the LCD MONITOR then attempt to code it. Once the unit is coded
you can unplug the camera or the LCD MONITOR and move it to your
desired location.
Coding Monitor to the Camera(s)
• Connect the CAMERA POWER CORD to the CAMERA. (Hint: The CAM-
ERA POWER CORD is the one with the red LED light) and plug it into a
wall outlet.
• Power on the CAMERA by pressing the POWER ON/OFF Button.
• Connect the BABY MONITOR POWER CORD to the BABY MONITOR
and plug it into a wall outlet.
• Power on the BABY MONITOR by pressing the POWER/SLEEP (DIM
SCREEN) button and holding it pressed for several seconds.
• If you want to place the Baby Monitor on a at surface, Pull and Twist
the “Monitor Stand” located on the back of the “BABY MONITOR.”
• To Code the CAMERA with the BABY MONITOR:
a. On the CAMERA press and hold the POWER ON/OFF Button for 3
seconds until you see the Green LED light ashing.
b. On the BABY MONITOR press the “Code” button on the side of
the monitor.
c. Within 10-15 seconds you should see the static on the BABY
MONITOR disappear and then see the view through the CAMERA
on the BABY MONITOR.
To Next Page
Loading...
General