4
Please carefully read the safety
instructions before using the
appliance.
LpA (dB(A)) <70
ROTATING HOT AIR
STYLER
BAB2770E
FEATURES
• 40 mm ceramic technology
round brush. Boar and nylon bris-
tles with epoxide tip bristles
• 50 mm ceramic technology
round brush. Boar and nylon bris-
tles with epoxide tip bristles
• 800W power
• 2 temperature settings + ‘cool-
air’ setting
• Two-way rotation
• Ionic technology
• Swivel cord
• Hinged rear lter
INSTRUCTIONS FOR USE
• After shampoo, towel dry and un-
tangle hair carefully.
• Use the hot-air brush on pre-
dried, slightly damp hair that is
completely tangle free.
• Use clips to separate hair so that
you can work on one section at
a time. Start with the sections
underneath. Sections should be
a maximum of 2 cm wide and as
even as possible.
Attaching and removing the
brush attachments
Slip a brush attachment on the
body of the unit and then lock it
using the lock button on the top
of the brush attachment.
To remove a brush attachment,
unlock it and gently pull it o.
Two-way rotation
To roll the section of hair around
the rotating head automatically,
press the button for the desired
direction (right or left) and hold
throughout the blow-drying. The
right or left rotation corresponds
to the handling as well as to the
desired eect of blow-drying
under or out. To stop rotating, re-
lease the button.
Using the rotating brush
• To prepare the section and to
untangle, lift the roots of the
small section and straighten the
section, with the unit set to hot,
in one or two strokes but without
turning the brush.
• Hold the section of hair at a 90°
angle to the head so that the hair
underneath doesn’t get tangled.
• Slide the brush over the section
while turning the brush, but not
completely, repeat several times
while sliding the brush from the
roots to the tips.
• Finish with a full turn of the sec-
tion around the brush from roots
to tips, hold a few seconds so that
the section is completely heated
and shaped and so that the roots
are lifted.
ENGLISH
To Next Page
Loading...
