BaByliss SL33E - Interpreting the Data; Change in Weight (Δ Kg)

- 11 -
Guest mode:
• Place the scale on a hard, level and at surface
• Lightly tap the centre of the scale with your foot to
turn it on
• Wait until the screen displays “00.0KG”
• The scale is ready to be used
• Step onto the scale
• A graph will wind up in the spiral while weight is taken.
• Your weight will be displayed on the screen and will
remain displayed for a few seconds
• Then the scale goes out automatically
User mode:
• Before the rst use, the scale should be programmed
by the user (cf. PROGRAMMING section).
• Place the scale on a hard, level and at surface.
• Using your foot, press the button corresponding to
your user number.
• The screen will display your user number and
“00.0KG”.
• The scale is ready to be used.
• Step onto the scale.
• A graph winding up in a spiral appears and shows you
that the calculation of the data is in progress. When
the end point of the graph gets to the middle, the
calculation is complete.
• “000” will ash on the screen.
• Your weight, your BMI, the dierence in weight com
-
pared to the previous weighing (indicated by “∆ Kg”)
and the coloured indicator related to this dierence
and the graph that summarises the change in your
weight are instantly displayed for a few seconds.
Note: When using the scale for the rst time, change in
weight ( ΔKG) will show «0.0».
• Your weight is automatically saved in the memory of
the scale. The scale will beep to conrm the informa-
tion has been saved.
• The scale will go out automatically after a few seconds.
INTERPRETING THE DATA:
a. Change in weight (∆ Kg)
The scale records your weight after each use. It au-