10
Top Tips
• Use on clean, dry hair.
• If possible, when using for the
rst time, try and grow the facial
hair for a few days before cutting.
This will give a better result, as
the facial hair will feel thicker.
• Set the cutting length as required.
• It is always best to start cutting
with a longer length rst, then
trim again if the length is longer
than desired.
• Hold the FX775E against the
hair, the teeth of the comb guide
should be pointing upwards and
should be at against the face.
• Move the trimmer upwards
through the hair, a little at a
time, against the direction of hair
growth.
• The FX775E will work most
eectively when cutting through
the hair at its own speed – never
force through the hair. You may
experience a little resistance
when trimming the neck area,
where hair is thicker and grows in
many dierent directions. This is
completely normal.
• Just like shaving, extra time
should be given when trimming
under the neck area, as again
this is where hairs grow in many
dierent directions.
• Never switch the trimmer o
whilst in the hair.
CLEANING & MAINTENANCE
• Regular cleaning will maintain
the high performance of the
FX775E.
• Switch o and remove the power
cord if connected.
• Detach the comb guide by gently
moving aside each one of its side
and ipping it over to the back of
the unit.
• Use the cleaning brush supplied
to brush away any hair and
debris. Do not use a sharp object
to clean the trimmer blade.
• The blades can be removed to aid
cleaning.
• To remove the blades hold
the handle of the FX775E with
one hand, place your thumb
underneath the blades and push
the blades away from the handle.
• Gently blow away any hair
trapped beneath the blades.
• The blades can be rinsed under
the tap. After rinsing the blades
they may need to be oiled. See
oiling instructions below.
• Before re-attaching blade to the
trimmer, ensure the blades are
dry and moving blade is in the
centre. Please refer to g. 3.
Fig. 3
To Next Page
Loading...
