3. If driving upwards on a steep slope at low pre-set speed settings, the SPEED SET control
may need to be increased to provide sufficient torque to climb the slope. Remember to
reset the SPEED SET control when resuming flat ground or downhill use.
4. To stop, just release the lever. It is spring loaded to return to the rest position. The machine
will slow to a stop and then the brake will lock to prevent further unwanted movement,
particularly useful if operating on a slope. The machine will travel up to 2 metres before
stopping, dependant on operating speed and slope angle.
Ensure this is considered when
desiring to stop.
5. If it is necessary to manually move the machine, the power switch must be in the OFF
position and the brake lever in the Freewheel position. The brake lever is located under the
front left-hand side of the machine.
Care must be taken if it is required to place the brake in the FREEWHEEL position when on
a significant slope as the machine will no longer be controlled by the brake lock system.
6. Do not allow the machine to pass through pools of water that exceed 50mm depth. Water
damage will not be covered by warranty.
To Next Page
Loading...
Need help?
General
