Backyard Products GABLE - WING WALL PANELS ASSEMBLY; PARTS REQUIRED FOR WING WALL PANELS; ASSEMBLING WING WALL PANELS

1"
(2,5 cm)
3/4"
(1,9 cm)
1"
(2,5 cm)
3/4"
(1,9 cm)
6"
(15,2 cm)
3/4"
(1,9 cm)
3/4"
(1,9 cm)
6"
(15,2 cm)
Gauge Block
Gauge Block
12"
(30,5 cm)
27
Place LEFT panel on back frame as shown with primed side facing up.
BEGIN
Use a 3/4" gauge block at edges of panel.
1
Secure with 2" nails spaced 6" apart on edges and 12" apart inside panel. .
Do not nail
in groove.
BACK WALL PANELS
2" (5 cm)
PARTS REQUIRED:
3/4" GAUGE
BLOCK
DOOR
x32
Maintain 1" measurement as shown.
Fig. A
Fig. B
Primed side UP
For squareness maintain
3/4" measurement along
panel edges.
x1
3/8 x 48 x 84"
(1 x 122 x 213,4 cm)