Need help?Do you have a question about the Backyard Products GABLE 10 x 12 and is the answer not in the manual?
Assemble gable panels: left, middle, and right sections.
Construct gable framing: overhangs and connections.
Assemble and complete gable units with GPC parts.
Install main roof rafters, ensuring correct alignment and securing.
Assemble the dormer wall structure using specified parts.
Install dormer panels, frame, rafters, and related components.
Assemble dormer soffit blocks with KDA and UN parts.
Install eave fascia and framing components.
Install main roof panels, ensuring proper alignment and securing.
Install roof panels on the dormer sides.
Apply dormer felt and install flashing for weather protection.
Install dormer flashing and shingles for roof completion.
Assemble the dormer roof unit on a flat surface.
Assembly of the dormer side soffit components.
Install the assembled dormer roof unit onto the main structure.
Installation of the dormer fascia trim.
Procedure for installing dormer windows.
Installation of trim around the dormer.
Installation of trim specifically for dormer windows.
Installation of soffit boards on gable ends.
Installation of soffit boards on the eave sides.
Install dormer side eave soffit boards flush at rafter ends and seams.
Position and secure gable fascia boards flush to peak and roof panels.
Position and secure eave side fascia boards flush to roof panels.
Orient door parts and attach temporary supports OO and GAA.
Install door stiffener, center doors, and attach hinge boards.
Reinforce door trim, attach horizontal rails, and center WR trim.
Apply caulk and secure transom windows from the back of the door.
Center and secure door stiffeners OO on left and right doors.
Place and install spring bolts on door stiffeners.
Install door handle, inside handle, and decorative hinges.
Install trim boards at the corners of the structure.
Assemble loft joists and install them into the structure.
Assemble and install shelf supports and panels.
Assemble and install work bench supports and panels.
Position EHT parts and fasten RGD slats to form shutters.
Install large windows, ensuring proper sealing and leveling.
Seal and secure transom windows on the doors.
Measure, align, and install RNA and IDA window trim.
Install FF trim and attach shutters to RNA and FF.
Install vents in each gable, caulking flanges and securing with screws.
Install shingles on the roof, from starter row to the peak.
Prepare and install ridge cap shingles to finish the roof.
General| Size | 10 x 12 |
|---|---|
| Category | Garden Houses |
| Brand | Backyard Products |
| Material | Wood |
| Roof Style | Gable |
| Window Included | Yes |
| Model | GABLE |
To Next Page
