EasyManuals Logo

Bad Boy REBEL Series User Manual

Bad Boy REBEL Series
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
PAGE 19
SECTION 12: DRIVE BELT
Shown in Fig. 14 is the tensioner for the pump belt. Adjusting this will either increase or decrease tension on
the belt. Use a 3/4” wrench to loosen the jam nuts and either tighten for more belt tension or loosen for less belt
tension.
The tension should be adjusted so that there is between 60 and 65 lbs. of tension on the belt and recheck belt
tension after half an hour. This can be checked with a belt tension gauge (Part Number 041-9999-00) as shown
in Fig. 15.
Tensioner
Adjuster
Tensioner
Adjuster
Belt Tension Gauge
Fig. 14
Fig. 15

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bad Boy REBEL Series and is the answer not in the manual?

Bad Boy REBEL Series Specifications

General IconGeneral
Spindle MaterialCast Iron
Self-PropelledYes
Engine OptionsKawasaki
Cutting Width61 inches
Engine ManufacturerKawasaki
Engine TypeGasoline
Deck MaterialSteel
WeightVaries by model
Mulching CapabilityOptional
Horsepower22 HP, 23 HP, 27 HP

Related product manuals