Bagela BA 10000 - User Manual

Questions and Answers

R
rodriguezanthonyAug 18, 2025
What to do if Bagela BA 10000 Construction Equipment burner is on, flame is on, but goes out again and malfunction lamp burns?
- B
  Brandon WillisAug 18, 2025
  If the burner ignites but the flame goes out and the malfunction lamp illuminates, it could be due to a defective photosensor, so check the connection of the photosensor and replace it if necessary. The burner head adjustment may be incorrect, so check the basic settings. Alternatively, the oil firing control might be defective, so replace it.
D
Darren WilliamsAug 28, 2025
What to do if the motor of Bagela BA 10000 Construction Equipment burner does not turn?
- D
  Donald NixonAug 28, 2025
  If the burner motor doesn't turn, the cause may be that there is no power supply. To solve this, check the power supply and operate the overload switch at the generator.
S
scott09Nov 8, 2025
What to do if Bagela BA 10000 Construction Equipment burner is on but there is no flame and the malfunction lamp is on?
- B
  bduranNov 8, 2025
  If the burner is on, but there is no flame and the malfunction lamp is lit, several issues could be the cause. It could be that the filter is blocked, so replace the filter cartridge and clean the filter strainer. The pump may be drawing in air, so fill the fuel oil tank, replace the O-rings, check the suction line for leaks, and shut the vent cock. The photosensor might be getting outside light, so push the photosensor into the bushing, ensuring the glass side faces the tumbler. A blocked nozzle could also be the cause, so replace the nozzle. Check the transformer, cables, and ignition electrodes and replace the ignition electrodes if there is no ignition spark. Also, check the plug for proper seating and replace the solenoid valve if it is defective. Verify the generator voltage is at 23...