EasyManua.ls Logo

Baier BSS 607M - Operation and Wet Cleaning; Wet Vacuum Cleaning Procedures; Appliance Controls and Operation

Baier BSS 607M
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 4
DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Illustration
Remove the brush strips.
Install the rubber lips.
Illustration
Precisely fit the plug into the suction
connection.
Insert the plug up to the stop.
Illustration
Release and remove the suction head.
Pull out the fleece filter bag on the
flange towards the top.
Tightly close the fleece filter bag with
lock cap.
Dispose of the fleece filter bag accord-
ing to the local provisions.
Insert and lock the suction head.
To suck wet dirt, first remove the fleece
filter bag.
Illustration
Release and remove the suction head.
Put the disposal bag over.
Pull the opening of the disposal bag out
toward the back over the suction sup-
port.
Tightly close the disposal bag with ca-
ble tie underneath the opening.
Remove disposal bag.
Dispose of the disposal bag according
to the local provisions.
Insert and lock the suction head.
To suck wet dirt, always remove the dis-
posal bag.
If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
If the maximum liquid level is reached
the appliance will turn off automatically.
In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Illustration
The suction hose is equipped with a clip
system. All accessories with a nominal
width of 35 mm can be connected.
Plug in the mains plug.
Set the rotary switch to the desired pro-
gram.
Set the suction output (min - max) at the
rotary switch.
Wet vacuum cleaning
Inserting the rubber lips
Close the suction connection
Remove the fleece filter bag
Removing the dust disposal bag
General
Clip connection
Operation
Rotating knob
Appliance OFF
Appliance ON
Automatic filter cleaning: OFF
Appliance ON
Automatic filter cleaning: maxi-
mum interval
Appliance ON
Automatic filter cleaning: mini-
mum interval
Turning on the Appliance
Adjust the suction output
19EN

Table of Contents

Related product manuals