To Next PageTo Next PageHow to fix cylinders not retracting on Baileigh Industrial Construction Equipment?
If the cylinders on your Baileigh Industrial Construction Equipment are not retracting fully or are out of sequence, perform the dry run sequence as outlined in section 8 of the manual under operation.
Why doesn't my Baileigh Industrial RDB-150 Construction Equipment move forward or build up pressure?
There are a couple of reasons why your Baileigh Industrial Construction Equipment might not be moving forward or building pressure. First, the autostop switch position might be incorrect. Ensure the autostop dial's micro switch roller is riding on the outside perimeter of the dial and is depressed. Tighten the autostop adjusting knob until the autostop dial plate is in the same plane as the micro switch roller. Another potential cause is the solenoid switch. Check that the solenoid valve wires are connected. To check its functionality, extend the cylinder fully, let the machine deadhead and build up pressure to approximately 2000 Psi. Then, rotate the autostop dial to the detent position; the pressure should drop to 0 Psi.
Why Baileigh Industrial RDB-150 Construction Equipment doesn't move forward?
There are a couple of reasons why your Baileigh Industrial Construction Equipment might not be moving forward or is moving slowly and not building pressure: * **Incorrect autostop switch position:** Ensure the autostop dial has the micro switch roller riding on the outside of the perimeter of the dial. The micro switch must be depressed for the machine to work. If the roller is in the detent position or not in line with the autostop dial, the machine will be in the stop position. Tighten the autostop adjusting knob until the autostop dial plate comes into the same plane as the micro switch roller. * **Solenoid switch:** Check that the solenoid valve wires are connected. To check its functionality, extend the cylinder all the way, let the machine deadhead and build up pressure to appro...
Understanding the safety alert symbol for potential personal injury.
Defining signal words like DANGER, WARNING, CAUTION, NOTICE.
Machine voltage, frequency, and power source requirements.
General| Brand | Baileigh Industrial |
|---|---|
| Model | RDB-150 |
| Category | Construction Equipment |
| Language | English |
