Baileigh PL-1236E-DRO

Questions and Answers

K
Katie HoffmanSep 23, 2025
How to loosen barrel lock lever on Baileigh Lathe?
- A
  Angela HernandezSep 23, 2025
  If the barrel lock lever is tight on your Baileigh Lathe, loosen the lever.
P
Paula SullivanAug 23, 2025
How to reset emergency stop button on Baileigh PL-1236E-DRO?
- H
  Heather TannerAug 25, 2025
  If the emergency stop button is engaged on your Baileigh Lathe, release it by turning the knob to the right.
S
Spencer WilcoxAug 25, 2025
What to do if V-Belts are slipping on Baileigh PL-1236E-DRO?
- K
  Kimberly CampbellAug 26, 2025
  If the V-Belts are slipping on your Baileigh Lathe, inspect, tension, and replace the belts.
J
Jessica SmithAug 26, 2025
What to do if depth of cut is too much on Baileigh Lathe?
- D
  Deborah RodriguezAug 27, 2025
  If the depth of cut is too much on your Baileigh Lathe, use more passes to remove less material.
R
Rodney RandallAug 27, 2025
What to do if motor power cable is not connected properly on Baileigh PL-1236E-DRO Lathe?
- T
  tonybrownAug 27, 2025
  If the motor power cable is not connected properly on your Baileigh Lathe, check the cable connection and reconnect the cable. If the cable is worn out, change it.
J
Jon StewartSep 15, 2025
How to adjust cross slide backlash setting that is too tight on Baileigh PL-1236E-DRO Lathe?
- B
  brownjenniferSep 15, 2025
  If the cross slide backlash setting is too tight on your Baileigh Lathe, loosen slightly until free.
T
Timothy HernandezSep 12, 2025
How to adjust mechanism for lead screw worn out on Baileigh PL-1236E-DRO?
- C
  Crystal WashingtonSep 12, 2025
  If the mechanism for the lead screw is worn out or in need of adjustment on your Baileigh Lathe, tighten the fasteners on the lead screw mechanism and adjust the cross slide for backlash.
D
David ParkerSep 14, 2025
How to clean dirty gibs on Baileigh PL-1236E-DRO?
- R
  Robert RiggsSep 14, 2025
  If the gibs are dirty on your Baileigh Lathe, remove the gibs, clean the ways, lubricate, replace, and re-adjust the gibs.
A
Amanda HurleySep 5, 2025
What to do if I have unbalanced chuck or faceplate on Baileigh Lathe?
- A
  Amber CastilloSep 5, 2025
  If you have an unbalanced chuck or faceplate on your Baileigh Lathe, have the chuck or faceplate either re-balanced or replaced.
T
Thomas BallardSep 2, 2025
What to do if Forward/Reverse lever on the carriage is in neutral on Baileigh PL-1236E-DRO Lathe?
- J
  jenniferwilsonSep 3, 2025
  If the Forward/Reverse lever on the carriage of your Baileigh Lathe is in neutral, make sure the lever is either in the Forward or Reverse position.