Figure 3. Location of
Control Board Fuse
Control board
fuse
Flip the top cover to access the
control board
Phillips screws
Control Board Fuse Replacement
Hook the retainer bracket onto the front of the top cover.8.
Place the top cover back into position. Replace all screws.9.
NOTE: It may be necessary to remove the air filter to correctly
position the lower portion of the retainer bracket inside the
unit.
Reconnect the warming unit to the power source.10.
Record the maintenance action taken and the hours of 11.
operation (read from the hour meter) in the Maintenance
Log section.
Retainer bracket
Retainer bracket
hooks into top cover
and is secured by
screws through two
front “feet”
Bair Hugger Model 505 Service Manual
8
To Next Page
Loading...
