*Tie all wires away from sharp, hot, and/or rotating components.
* Re-torque all the fasteners after 100 miles.
*Your install is now complete! Thank you for choosing Baja Designs.
If you want to disable the corner-illumination fog light feature, you can:
• Turn off the automatic headlights and use the manual mode, or
• Contact your local dealership to assist in disabling the feature.
13. Install your light in the fog light
opening and re-install the three
fasteners removed in step 2. Make
sure you fog light is sitting flat and not
interfering with the tabs around the
mounting location. Trim the tabs
more if needed.
14. Re-install the trim panel removed
in step 1. Make the 2 clips are
engaged.
15. Repeat Steps 1-14 for the opposite
side of the vehicle.
To Previous Page
Loading...
