23
RESUMPTION OF SERVICE AFTER STORAGE
1. Remove the covering and remove the wooden blocks used in storing the vehicle.
Change the engine oil if the vehicle has been out of service for over 4 months.
2. Drain off the remaining atomized anti-rust oil from the fuel tank, followed by lling it
with fresh gasoline therein.
3. Prior to driving, all the required check-ups must be made. It is better to drive it at a
low speed in an open area to test its performance before normal operation.
TABLE AND TORQUE OF FASTENERS
Ser. No. Fastener Torque (Newton/m)
1 Front wheel axle nut 35-45
2 Rear wheel axle nut 50-60
3 Nut for tightening upper joining plate of front
fork with vertical tube
40-50
4 Nut for xing engine 20-25
5 Rear arm nut 35-50
6 Exhaust silencer nut 20-25
7 Bolt for tightening upper joining plate of
front fork with shock absorber
15-20
8 Bolt for xing footrest 20-25
To Next Page
Loading...
