Do not store the battery in rooms with temperatures that exceed 122
degrees F or -10 degrees F. This may cause the battery to deteriorate.
If within 30 days the scooter is not used, charge the battery and keep the
device in a cool, dry place. Every 60 days you need to charge the
battery, otherwise there is the likelihood of its failure, which is not
subject to warranty services.
Avoid a full discharge of the device, it will reduce the battery life.
When using the device at normal room temperature, the battery will
be able to ride much greater distance and its performance will be
improved.
Note: A fully charge scooter runs about 120-180 days of standby time.
The battery has a smart chip, that stores information about its charging-
discharging. If you are not charging the battery for a long time, it can
cause serious damage, for which it decreases the capibility to charge
the device again. This kind of damage is not included in warranty
service. (Caution: Do not disassemble the device by unauthorized
people, as there is a risk of electric shock or serious injury as result
of a short circuit.
Adjusting a brake disc
If the brake is tight, using a M5 hex wrench and loosen screws of brake
disc tensioner pulley, slightly shorten a length of a tail brake cable,then
re-tighten a tensioner pulley.
If you feel the brake is loose, loosen tension pulley screw, pull the brake
cable to slightly tighten and increase a length of its tail. Re-tighten
tension pulley screws.
Adjusting handle bars
Use a M5 hex wrench, loosen and tighten two screws near the folding
mechanism to adjust handle bars to desired setting.
10
/
10
To Previous Page
Loading...
