Baker BP Dominator 3650E - Maintenance and Blade Management; General Clean Up and Daily Maintenance

33
MAINTENANCE
General Clean Up
Note: When possible, follow proper Lockout / Tagout procedures prior to cleaning any part of the
machine.
 On a daily basis use an air-hose to blow-off the dust and wood chips that accumulate in,
on and around the machine.
 The machine operator or clean-up person is closer to dangerous operating mechanisms of
the machine during clean up than during production – extra care should be taken.
 Do NOT clean with flammable or combustible materials.
 Follow applicable codes and standards with regards to:
 Ventilation and monitoring of work area for excessive accumulation of hazardous
vapors
 Wearing personal protective equipment for handling materials
 Using proper procedure for disposing of all waste materials
 During daily clean up and daily maintenance of the machinery it is advised that the
operator do a daily visual inspection of the equipment for anything that may have been
damaged or become loose during normal use.
Important Notice: Use extreme caution when
performing maintenance or making repairs
with the carriage head elevated.
A worn or damaged raise/lower drive belt may
result in the carriage head falling to the log
deck where a serious or fatal injury may occur.
Perform inspection and preventative maintenance per the
schedule and tasks noted on Page 30.