63
Head surges when
traveling the length of the
sawmill.
The track chains are loose.
At the back of the sawmill, on the left and right sides are the track
are chain adjustment bolts. Both of the track chain should have
approximately 2" of slack when lifted at the center of the mill.
Tighten the track chain(s) adjustment bolts until the correct amount
of slack is present at the center of the mill.
clamp, or toe rollers will
not rise, but all pressures
are good.
The affected part is binding and requires lubrication. Grease the
appropriate part with grease.
To Next Page
Loading...