EasyManuals Logo

Baker GRUDGEBOX User Manual

Baker GRUDGEBOX
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
PV4-118310
PAGE 23
FINAL STEPS
SPEEDOMETER, GEAR INDICATOR, & CRUISE CONTROL
The GrudgeBox has different gear ratios than the stock transmission (except GrudgeBox 5
th
gear is the same as stock 6
th
gear, 1:1). This changes the input to the ECM. The 41-tooth
reluctor ring in the GrudgeBox compensates to correct the speedometer within ± 2 mph with
no re-flash to the ECM. However, the gear indicator and cruise control may only operate in 5
th
gear. To correct the gear indicator in all gears and enable cruise control in 3
rd
, 4
th
, and 6
th
, an
ECM re-flash is required.
ECM RE-FLASH VALUES
1. Re-install the top cover with the new gasket provided. Button up the primary, exhaust, shift
linkage, and floorboards/footpegs per your Factory Service Manual. Make sure to re-install
the primary drain plug and fill the primary with fluid.
2. You have successfully completed the installation of your new transmission. Be observant
of basic transmission function and overall vehicle operation during the first 20 miles.
Check for leaks after your first ride. Provided there are no issues, ride on and enjoy your
new BAKER GrudgeBox.
FINISH LINE
GrudgeBox | Dynojet Power Vision
1
st
0.15441
2
nd
0.22296
3
rd
0.30560
4
th
0.38679
5
th
0.49366
6
th
0.53426

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Baker GRUDGEBOX and is the answer not in the manual?

Baker GRUDGEBOX Specifications

General IconGeneral
BrandBaker
ModelGRUDGEBOX
CategoryMotorcycle Accessories
LanguageEnglish