BALAY 3TS384XT - Page 41

Troubleshooting en
41
Fault Cause and troubleshooting
The programme does
not start.
2. Press Inicio/Pausa + carga to start the programme.
Childproof lock is activated.
▶ Deactivate childproof lock.
→"Deactivating the childproof lock", Page32
Progr. diferida is activated.
▶ Check whether Progr. diferida is activated.
→"Buttons", Page23
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press Inicio/Pausa + carga to start the programme.
The door cannot
beopened.
–––– is activated.
▶ Continue the programme by selecting or and
pressing Inicio/Pausa + carga.
→"Resuming the programme when the programme
status is Rinse Hold", Page32
The temperature is too high.
▶ Wait until the temperature has dropped.
▶ Cancel the programme.
→"Cancelling the programme", Page31
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page24
Power failure.
▶ Open the door using the emergency release.
→"Emergency release", Page47
The water is not drain-
ing.
Drain pipe or water outlet hose is blocked.
▶ Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶ Ensure that the drain pipe and water drain hose are
not kinked or trapped.
Drain pump is blocked.
▶
→"Cleaning the drain pump", Page35
–––– is activated.
▶ Continue the programme by selecting or and
pressing Inicio/Pausa + carga.
→"Resuming the programme when the programme
status is Rinse Hold", Page32
The water outlet hose is connected too high.