BALAY 3VS300BA - Programme Control; Timer programming; End of programme; Switching off the appliance

en
16
Timer programming
*
* depending on model
You can delay the start of the programme
by 3, 6 or 9 hours.
Switch on ON/OFF switch
1
.
Keep pressing the Preselected starting
time button
5
until the appropriate
display 3 h, 6 h or 9 h is lit.
Press Start button
4
.
The preselected starting time
is activated.
To delete the preselected starting time,
keep pressing the Preselected starting
time button
5
until none of the
displays 3 h, 6 h or 9 h is lit.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the End
display
10
is lit.
Switching off the appliance
Short time after the end of the programme:
Switch off ON/OFF switch
1
.
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they
have cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
Switch off ON/OFF switch
1
.
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection or
is heated, first leave the door ajar for
several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch on
the ON/OFF switch
1
again.
Terminating the programme
(Reset)
Press Start button
4
for approx. 3 sec.
The remaining programme sequence
lasts approx. 1 more minute.
The End display
10
is lit, switch off
ON/OFF switch
1
.
Changing the programme
When the START button
4
has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (reset).