53857_02-97_A
Output Features Quadrant
J1 + W1 – 2-Speed Pump 1 3-B
J2 + W6 – Output tied to Pump 1 Low (J39 - P1-Lo) 4-B
– OR output tied to Circ Pump (J39 - Circ)
J3 + W7 – Circ Pump 5-B
J4 + W13 – Ozone (Separate Relay 120V or 240V) 7-B
J5 + W8 – A.V. 6-B
J6 + W12 – 3-speed blower 8-B
J10 + W9 – Spa Light (12V or 120V/240V) (Check J37 setting) 8-C
J7 + W2 – Misc (120V or 240V) (Check J47 setting) 2-C
J8 + W5 – Fiber Optic (12V or 120V/240V) 4-C
(Check J47 + J49 setting)
J9 + W4 – Mister (12V or 120V/240V) (Check J29 setting) 5-C
J11 + W14 – 2-Speed Pump 2 5-D
J12 + W10 – 2-Speed Pump 3 (W30 to J94) 7-D
W3 – Sets Transformer Voltage (120V or 240V) 4-E
(Setting must match transformer installed in system.)
X-P632
Used for an additional 2-speed Pump output.
Relay control J2 plugs into the EXP I/O connector J36 on
the Main PCBA (Quadrant 7-E, near W10).
Expander boards that REPLACE the Blower function:
Relay control for these options is connected to J21 on the
Main PCBA (Quadrant 9-C, near W9). Do not use the
Blower Connector J6 if one of these is used.
X-P PN 53544
Used for an on-off Device without a fuse
X-B PN 53310
Used for an on-off Device with 10A fuse
X-P231 PN 53681
Used for an on-off Device with 30A fuse
PN 53680
Document PN 40593_E
09-20-2006
Pump 5 Pump 2
To J11
PS-25
Used to split the output from the Pump 2 Connector (J11)
into a single-speed Pump 2 and single-speed Pump 5.
White wire quick connect goes to Main PCB Red AC for
240 Pumps or to Wht AC for 120V Pumps.
PN 25094
White
Red
White
Green
Black
Green
White
Red
White
Green
Black
Green
Pump 4 Pump 3
To J12
PS-34
Used to split the output from the Pump 3 Connector (J12)
into a single-speed Pump 3 and single-speed Pump 4.
White wire quick connect goes to Main PCB Red AC for
240 Pumps or to Wht AC for 120V Pumps.
PN 25093
Red
Black
White
Green
Sequencer
SS Pump
SS Pump
ELS-VALVE
Used to split the output from a single-speed Pump to allow
a Valve Sequencer to be powered by the pump’s output.
PN 22934
G
R
B
W
J1
W1
J2
J6
F30A 480V
X-P632
PN 53680
P/N 22909 REV B
Expander Options