53857_02-97_A
Jumper Definitions
Jumpers Key
J29 .........Jumper on Pins 1 and 2 will power J9-pin 1 (Mister) at 12 Volts AC.
Jumper on Pins 2 and 3 will power J9-pin 1 (Mister) at 120/240 Volts AC.
Note: W4 controls voltage on return line of J9-pin 3 and must be set for the same voltage.
J37 .........Jumper on Pins 1 and 2 will power one leg of J10-pin 2 (Spa Light) at 120/240 Volts AC.
Jumper on Pins 2 and 3 will power one leg of J10-pin 2 (Spa Light) at 12 Volts AC.
Note: W9 controls voltage on the return line of J10-pin 1 and must be set for the same voltage.
J39 .........Jumper on Pins 1 and 2 will power J2 pin 2 with Pump 1 Low.
Jumper on Pins 2 and 3 will power J2 pin 2 with the Circ Pump.
Note: W6 controls voltage on common line of J2-pin 3
J47 .........Jumper on Pins 1 and 2 will power J8 pin 2 (Fiber Optic Light) and J7 at 120/240 Volts AC.
Jumper on Pins 2 and 3 will power J8 pin 2 (Fiber Optic Light) at 12 Volts AC.
Note: J47 and J49 must be set for the same voltage. W5 controls voltage on return line of J8-pin 3 and
must be set to the same voltage.
J49 .........Jumper on Pins 2 and 3 will power J8 pin 1 (Fiber Optic Wheel) at 120/240 Volts AC.
Jumper on Pins 1 and 2 will power J8 pin 1 (Fiber Optic Wheel) at 12 Volts AC.
Note: J47 and J49 must be set for the same voltage. W5 controls voltage on return line of J8-pin 3 and
must be set to the same voltage.
J91 .........Jumper on 1 Pin only enables Real Time Clock function, for use with time capable panels.
Jumper on Pins 1 and 2 will disable RTC function, for use with non-time capable panels.
WARNING:
•Setting Jumpers incorrectly may cause abnormal system behavior and/or damage to system components.
•Refer to Jumper illustration in this hot sheet for correct settings for this system.
•Contact Balboa if you require additional configuration pages added to this hot sheet.
To Next Page
Loading...
