BALDR 330 - LCD SCREEN DETAILS; Understanding LCD Information; OPERATING INSTRUCTIONS; Charging the Power Station

Connect the provided AC Wall power adapter to Input , and allow BALDR 330 to fully charge
prior to use, approx. 5-7 hours. When charging, the LCD Screen will be illuminated, and the
LCD display will provide Battery level Indicator H , BALDR 330 is fully charged when the level
is 100%. It is recommended to fully charge BALDR 330 every 3 months to maintain the health
of the battery pack.
BATTERY LEVEL INDICATOR H : The battery level is provided by percentage of battery
charge corresponding to the number of bars and percentage displayed. The segments in the
battery level correspond to the current state of charge, 0-5% empty, 6-20% one segment,
21-40% two segments, 41-60% three segments, 61-80% four segments, and all five are lit
when charge level is above 81%.
Provides the user live telemetry data on time to completely charge, or deplete the battery based
upon the energy entering or leaving the battery.
Highly recommend to fully charge BALDR 330 when first use. Higher battery level indicator
show, more precise the data will indicate.
PLEASE BE AWARE that this value can adjust multiple times as the energy draw changes from
the connected devices. This is evident during initial activation of ports with a connected device.
RECOMMENDED back to charge the BALDR 330 when battery indicate less than 20%.
Note that when you first plug in a power source, whether it's a solar panel or a wall charger, the
BALDR 330 may take a minute to detect and adjust its charge circuitry before it starts drawing
power from the source.
INPUT Status I: The BALDR 330 is capable of providing input energy in watts.
BALDR 330 charge process is normal when the input watts is 20-60 which show on the battery
level indicator.
DC Output Status J: The display will provide output watts of the DC port .
AC Output Status K: The display will provide output watts of the AC port .
The output watts of USB port will NOT display on the LCD Screen .
LCD Screen will enter sleep mode after 120 seconds of inactivity (no new output load
detected), and will "wake up" when inputting a charging cord or when any button is pressed.
DETAILS DISPLAYED ON LCD
OPERATING INSTRUCTIONS
6
2 3
1
8
1
1
6
CHARGING BALDR 330