Balex BXHT 6025 - Maintenance Procedures; Maintenance Chart

35
ENGLISH EN
7. Maintenance
Maintenance, replacement or repair of the device and emission control systems must be
performed by an authorized service center.
Maintenance chart
System/
Components
Procedure
Before
use
Every
25
hours
Every
50
hours
Every
100
hours
Note
Engine
Fuel leaks,
fuel spillage
Wipe out
ü
Fuel tank, air lter,
fuel lter
Inspect/Clean
ü ü
Replace, if
necessary
Idle adjusting screw
See adjusting
idling speed
ü
Replace
carburetor if
necessary
Spark plug
Clean and
readjust plug
gap
ü
Gap 0.65 mm
Replace, if
necessary
Cylinder ns, intake
air cooling vent
Clean
ü
Mu󰀪er, spark
arrester, cylinder
exhaust port
Clean
ü
Hedge
trimmer
Throttle lever,
ignition switch
Check
operation
ü
Cutting parts
Replace if
something’s
wrong
ü
Gear case Grease
ü
Screws/nuts/bolts
Tighten/
Replace
ü ü
WARNING
Make sure that the engine has stopped and is cool before performing any service to the
machine. Contact with moving blade or hot mu󰀪er may result in a personal injury.