Bally MONTE CARLO S6000 User Manual

BALLY S6000 MONTE CARLO - QUICK SET-UP GUIDE
1) If this is a new set up, begin with setting up the progressive Cham II board. Make sure the
Mikohn Cham II Eprom is installed on the board as often times it is removed by the casino for security
reasons. If this is a pre-running machine and you have allowed your rechargeable battery to die on your
Cham II board then proceed to Step 2. If your Cham II is functioning properly and showing your correct
jackpot amount in the display window then proceed to Step 5 below.
2) Make sure the display is hooked up and then power up the Mikohn box. Set up the on-board
options using the toggle switch and buttons with the display powered on. Use the following settings:
Menu = SYST
Test = OFF
Birth = OFF
Save to = RAMD
Show load = YES
Show C1 = YES
Symbol = NONE
Sound = Disable
Menu = ADDR
GRADDR = 4
ID ADDR = 64
RTE ADDR = OFF
MACH ADDR = 2

Bally MONTE CARLO S6000 Specifications

General

Category	Arcade Game Machines
Manufacturer	Bally
Model	MONTE CARLO S6000
Game	Monte Carlo
Players	1

Summary

Bally S6000 Monte Carlo Quick Set-Up Guide

Progressive Board Setup and Initial Checks

Set up the progressive Cham II board and check machine status before proceeding.

Display and On-Board Options Configuration

Configure display and on-board settings using toggle switches and buttons.

Cham II Parameter Programming

Program Cham II parameters via computer using PSP3.0 software.

Final Reassembly and Connections

Reinstall Cham II board and reconnect all harnesses to the display.

Computer Board Battery Test and Component Settings

Test computer board battery and verify DS1, DS2, DS3, and jumper settings.

Personality Chip Installation and Board Clearing

Install personality chips and use clear chips for board initialization.

Parameter and Setting Adjustments

Adjust machine parameters and settings using Bet Max and Spin buttons.