OPERATOR’S MANUAL with Maintenance Information
Transport and Lifting Instructions
36
√ Only qualified riggers should rig and lift the
machine.
√ Only qualified forklift operators should lift
the machine with a forklift.
√ Be sure the crane capacity, loading
surfaces and straps or lines are sufficient to
withstand the machine weight. See the
serial plate for the machine weight.
Lifting the Machine with a
Forklift
Be sure the extension deck, controls and
component trays are secure. Remove all loose
items on the machine.
Fully lower the platform. The platform must
remain lowered during all loading and
transport procedures.
Use the forklift pockets located on both sides
of the ladder.
Position the forklift forks in position with the
forklift pockets.
Drive forward to the full extent of the forks.
Raise the machine 6 in / 15 cm and then tilt the
forks back slightly to keep the machine secure.
Be sure the machine is level when lowering
the forks.
Lifting the machine from the
side can result in component damage.
To Next Page
Loading...