Ban Seok BV-302 - User Manual

Questions and Answers

G
George DavenportAug 4, 2025
What to do if my Ban Seok Control Unit is not dispensing?
- M
  Mrs. Kimberly McgeeAug 4, 2025
  If your Ban Seok Control Unit is not dispensing, there are several potential causes. The cylinder rod may not be working, in which case you should supply air into the valve on/off line. The fluid might be cured, so you should clean the valve. The fluid reservoir may need to be pressurized if the fluid is not being supplied. Ensure that the fluid is supplied. Also, check that the controller is turned on.
C
christopherjamesAug 13, 2025
Why is fluid leaking from the needle adapter on my Ban Seok Control Unit?
- N
  Nicole BlackburnAug 13, 2025
  Fluid leakage from the needle adapter of your Ban Seok Control Unit can occur if the needle adapter is unfastened or if the cylinder rod is worn out. In either case, clean the valve. If the adapter is unfastened, then fasten it. If the cylinder rod is worn out, replace it.
N
Nicole LongAug 25, 2025
What to do if there's fluid leakage between the under cap and middle cap of my Ban Seok BV-302?
- M
  Michele FisherAug 25, 2025
  If you notice fluid leaking between the under cap and middle cap of your Ban Seok Control Unit, it could be due to the seal cap and o-ring reaching the end of their lifetime. Clean the valve, and then replace the seal cap and o-ring.

Summary

Safety

For Your Safety

Guidelines for preventing injuries from fluid splashes, contact with liquids, and nozzle removal.

Valve Overuse Hazards

Risks associated with over-pressure, unauthorized alterations, and exceeding operation/fluid pressure limits.

Other Safety Precautions

Checks for hose damage, wear, and ensuring proper joint tightening to prevent leaks.

Specifications

Principle of Operation

Installation and Operation

Connecting Lines

Instructions for connecting air-pressure and fluid lines, including tube cutting and installation precautions.

Operation Procedures

Steps for preparing the valve for use, including purging air and controlling dispensing volume.

Maintenance and Cleaning

Storing After Use

Recommendations for storing the valve after use, including nozzle protection and cleaning.

Operational Checks

Essential checks to perform during operation, focusing on air supply, connections, and nozzle condition.

Exploded View and Parts

Visual representation of the valve's components with a corresponding parts list for identification.

Cleaning Procedure

Procedure for cleaning the valve, involving pressure release and dispensing cleaning liquid.

Spare Parts List

A list of common spare parts for the dispensing valve, including part numbers and names.

Troubleshooting

Outside View and Dimensions

Ban Seok BV-302 Specifications

General

Brand	Ban Seok
Model	BV-302
Category	Control Unit
Language	English

Related product manuals

Ban Seok BV-520P

8 pages