Banana Pi BPI-M2+ - H3 Manual Build Howto

H3Manualbuildhowto
bananapiBPI-M2+useallwinnerH3chiponboard.
ThispagedescribestheprocesstocombineAllwinnersbinaryboot0,anSDKU-Boot,an
SDKlinuxkernelandotherbitstogethertocreateausefulSD-cardfromscratch,thebasis
forfurtherhacking.
ThispageisonlysuitedforH3baseddevices,pleaselookunderSeealsoforothermanual
buildhowtos.
Weofcoursedonotbuildawholedistribution,weonlybuildU-Boot,thekernelanda
handfuloftools,andthenuseanexistingrootfstogetausefulsystem.Dependingonthe
rootfssize,youmightwanttousea2GBorlargerSDCard.SD-cardpartitioningand
formattingwillbetakencareoflater.
Link:
http://linux-sunxi.org/H3_Manual_build_howto
BPI-M2+（BPI-M2Plus）H3quadcordsingleboardcomputer
70H3Manualbuildhowto