IT5000-C / IT6000-C
3/8” IT Tool
www.BAND-IT-IDEX.com
Document # P48850 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Page 5 of 36
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
Additional Safety Guidelines:
• Read this manual and become familiar with the tool before installing any clamps.
• Protective eyewear should be worn when connecting and disconnecting the tool to
compressed air sources and during operation.
• Wear appropriate gloves for handling steel while operating this tool, applying steel
clamps and removing scrap clamp tail.
• Clamp tensioning can be immediately stopped by releasing the tool trigger. If a remote
trigger is used, the system must be connected to allow for immediate disabling of the tool.
• When applying clamps, care should be taken to insure fingers and loose clothing are not
in the way of the clamp being applied.
• Never attempt to clamp objects which have a potential to burst, shatter or otherwise
cause bodily harm.
• Disconnect air supply and electrical power prior to maintenance and disassembly of tool
components.
• Liquids or lubricants should never be put into the air lines.
Environmental operating conditions are defined as:
• For Indoor Use ONLY
• Temperature range from 5°C to 40°C
• Max relative humidity 80% for temperatures up to 31°C. Allowable humidity then
decreases linearly to 50% at 40°C
• Conforms to Applicable Rated POLLUTION DEGREE 1
• Correct illumination for safety of operator (ISO 8995-89)
Safety Guidelines
To Next Page
Loading...