IT5000-C / IT6000-C
3/8” IT Tool
www.BAND-IT-IDEX.com
Document # P48850 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Page 6 of 36
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
Tool Overview
IT6000 C 0 0 0
IT6000 – 3/8” Tie-Lok
®
Ties
IT5000 – 3/8” JR
®
Clamps
Product model: Revisions are
not compatible
Feedback options:
0 – Standard Tool
1 – Data Feedback System
(obsolete)
2 – Cutoff Signal Sensor
Trigger options:
0 – Standard thumb trigger
1 – Connection for a remote trigger
(tool trigger disabled)
Packaging options:
0 – Tool with standard accessories
1 – Tool only
Model Identification
This machine is designed to automatically install clamps with repeatability and control.
• The tool consists of a tension system and a cutting system, both pneumatically controlled.
• The pneumatic system can be adjusted to provide appropriate clamp force for different
applications. As the tension pressure is increased, the output force of the tool increases.
• During the tension cycle, the tool continues to tension the band until the pre-set tension is
achieved. The tool stops tensioning when the pressure in the tension cylinder equals the inlet
tension pressure coming from the air controller module.
• After the tool has achieved the preset tension, a valve switches over to the cutoff cycle.
• The gripping system retains force on the clamp until after the knife is actuated, which forms a
locking feature and cuts the excess clamp tail.
To Next Page
Loading...