Band-it T30069 User Manual

BAND-IT IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # P15087 rev. J
© Copyright
BAND-IT IDEX, Inc. 2013
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 5
T30069
CP Hand Tool
Instruction
Manual
Safety Practices:
1. Read this manual and become familiar with the tool before use.
2. Protective eyewear should be worn during use.
3. Wear appropriate gloves for handling steel.
4. When applying clamps, care should be taken to insure fingers are not in contact with
the clamp during installation.
5. Never attempt to clamp objects which have the potential to burst, shatter or
otherwise cause bodily harm.
6. Do not use tool on live electrical sources.
Introduction:
The T30069 Center Punch Tool installs BAND-IT 3/8" and 5/8", 201 Stainless
Steel and Galvanized Carbon Steel clamps.
Table of Contents:
1. Introduction & Safety Practices
2. Operating Instructions
3. Tool Assembly
4. Repair Parts List
5. 3/8" Adapter & Warranty

Band-it T30069 Specifications

General

Brand	Band-it
Model	T30069
Category	Power Tool
Language	English

Summary

Introduction

Introduction to T30069 Center Punch Tool

The T30069 Center Punch Tool installs BAND-IT 3/8" and 5/8" clamps made of 201 Stainless Steel and Galvanized Carbon Steel.

Safety Practices

General Safety Guidelines

Essential safety guidelines for operating the BAND-IT T30069 tool, including protective gear and operational precautions.

Operating Instructions

Load Clamp

Push tension handle forward, insert clamp tail, and push all the way into the tool.

Tighten Clamp

Tighten clamp with short downward strokes, keeping tension handle down.

Lock Clamp

Hold tension handle down and lock clamp by hitting punch with a mallet.

Remove Clamp Tail

Pivot tool back and forth to break off tail, then remove it using the tension handle.

Tool Assembly

Disassembly and Assembly of Punch

Instructions on how to remove and replace the punch using specific components and retaining ball.

3/8" Adapter & Warranty

Installing the 3/8" Adapter

Steps to convert the T30069 tool for 3/8" clamps by attaching the adapter.

Warranty Information

Information on how to obtain warranty details for the product.