What to do if B&B ARMR Vertical Pivot does not respond when commanded?
If the gate operator isn't responding, here are some things to check: 1. Verify power at CONN 9 when a command is given. 2. Inspect the overload protector. 3. Check the PLC output and input. 4. Make sure safeties are clear and IR Beams are aligned. 5. Check the +24VDC at CONN3 pins 8 and 10.
Why does my B&B ARMR Vertical Pivot Gate Opener drive gate too slowly?
If your gate operator is moving the gate too slowly, consider the following: 1. Check for any obstructions or binding in the gate's movement. 2. Check the hydraulic fluid level in the reservoir. 3. Assess the quality of the hydraulic fluid; old fluid can become sludgy and may clog the internal filter.
What to do if B&B ARMR Gate Opener displays MAX Runtime Error?
If you're seeing a MAX Runtime Error, try these steps: 1. Check for any binding of the gate. 2. Check the fluid level in the reservoir. 3. Review the MAX RUN TIME setting in Parameters to ensure it's adequate for the gate size.
What to do if B&B ARMR Vertical Pivot Gate Opener blows fuses?
If the fuses are blowing, check the following: 1. Verify the incoming power to the Printed Circuit Board (PCB) is correct. 2. Ensure all external devices are sending the correct voltage to the PCB and that there are no shorts.
What to do if B&B ARMR Vertical Pivot electric motor turns but gate does not move?
If the electric motor is running but the gate isn't moving, consider these points: 1. Check the fluid level in the reservoir. 2. Check PLC outputs to see if Q1 turns on for an OPEN and/or Q2 turns on for a CLOSE. 3. Inspect for loose coupling between the electric motor and pump assembly. 4. Check for voltage between COM and HYD VAL 1 and 2 on CONN 1 of PCB, and ensure wires connections are tight.
Why PLC says Stop/Reset activated on my B&B ARMR Vertical Pivot Gate Opener?
If the PLC indicates Stop/Reset is activated: 1. If using an external push button, ensure the stop button has a normally closed contact. 2. If not using a button, ensure a jumper wire connects stop/reset and +24 stp/rst on CONN 3. 3. Check the wire connection between the J1Pin 9 connector and I7 of the PLC. 4. Verify the shunt is present on JP1 between pins 1 and 2. 5. Check F3.
Crucial instructions to reduce the risk of serious injury or death from gate operator use.
Configure the inherent safety pressure settings for obstruction detection.
Step-by-step guide to perform an initial operational test of the gate operator.
General| Brand | B&B ARMR |
|---|---|
| Model | Vertical Pivot |
| Category | Gate Opener |
| Language | English |
To Next Page
