B&D Automatic Technology Wireless WPE-1v1 - User Manual

Wiring and Installation Instructions
Safety Beam Kits
EASYBEAM P.E. 3-V1 KIT
ATA ORDER NO. 61904, B&D ORDER NO. 62626
ITEM DESCRIPTION QTY
14 EASYBEAM RX-TX SET 1
4 MOUNTING KIT 1
PE 2000TS KIT -
ATA ORDER NO. 61903, B&D ORDER NO. 62852
ITEM DESCRIPTION QTY
15 PE BEAM IR-2000TS 1
4 MOUNTING KIT 1
ACCESSORY KIT -
16 RESISTOR 2K2 PACK 1
17 RESISTOR 5K6 PACK 1
INTERFACE KIT V2 (ACB / DCB BOARDS ONLY) -
18 HARNESS P.E. RX 24AWG 10M 1
19 HARNESS P.E. RX-TX 17M 1
EasyBeam
TM
PE-3v1
PE 2000TS
WPE-1V1 KIT -
ATA ORDER NO. 61957, B&D ORDER NO. 70300
ITEM DESCRIPTION QTY
1 WPB-04.02 TX ASSEMBLY 1
2 WPB-04.02 RX ASSEMBLY 1
3 WPB-04.03 BASE STATION ASSEMBLY 1
4 MOUNTING KIT 1
FLUSH MOUNTING KIT -
5 PEB4-W1 BRACKET 2
6 TAPTITE SCREW “P” M3 X 8 8
7 SELF TAPPING SCREW M6 X 25 4
8 PLASTIC WALL PLUG 6.7 X 25 4
PEB4-W1 HARDWARE KIT 2 -
9 PLASTIC WALL PLUG 6.9 X 25 2
10 SELF TAPPING SCREW M6 X 25 2
11 TAPTITE SCREW “P” BLACK ZNC M3 X 12 8
12 HEX SERRATION FLANGE NUT M6 1
13 HEX SERRATION HEAD SCREW M6 X 16 1
Wireless WPE-1v1
Important Safety Instructions
WARNING!
• When using Safety beams, the doorway / gateway must be clear of all obstructions and
persons a all times. The location of the beams and manner in which they are installed
might not give safety protection at all times.
• The sensors need to be 100mm above the floor level, however, the exact position must
be chosen in such a manner that it suits the application, the environmental conditions
and provides maximum safety protection.
• When using auto close mode, a Safety beam must be fitted correctly and tested for
operation at regular intervals. Extreme caution is recommended when using auto close
mode. All safety rules must be followed.
ELECTROCUTION!
• Disconnect the power cord from mains power and battery backup (if installed) before
making any repairs or removing covers on openers.
CAUTION:
Fall from ladder • Ensure ladder is the correct type for job.
• Ensure ladder is on flat ground.
• Ensure user has 3 points of contact while on ladder.
Entrapment • Ensure the garage door / gate is in good working order by undertaking regular servicing.
• Safety beams must be installed if the closing force at the bottom edge of the door / gate
exceeds 400N (40kg)
Doc # 160044_07
Part # 13409
Released 14/12/17

B&D Automatic Technology Wireless WPE-1v1 Specifications