Bandit
16
Copyright 6/18
MODELS 60FM / 72FM
ATTACHING & DETACHING
Dierent skid steer loaders have dierent attachment systems, consult the manufacturer’s manual for
specics on attachment procedures. The skid steer must be able to meet the required amount of hydraulic
oil (see HYDRAULIC SECTION). The forestry mulcher attaches to the front of any skid steer that accepts a
universal quick attachment plate. The quick attach locks secure the forestry mulcher onto the front end of the
skid steer. It is important that the forestry mulcher is properly in place and locked. Failure to do this could
result in the forestry mulcher becoming detached from the skid steer, causing damage to the unit, skid steer,
and potentially causing injury to the operator and others in the area.
The forestry mulcher operates o the skid steer existing hydraulic system. Locate the hydraulic line couplers,
clean the hydraulic quick couplers, and attach the forestry mulcher’s hydraulic hoses. Follow proper safety
procedures when coupling the hydraulic hoses. Failure to do this could result in serious injury or death to the
operator.
The forestry mulcher does not come with quick coupler attachments, and the operator should install
quick coupler ttings appropriate for the skid steer. The quick coupler ttings can be purchased from Bandit
Industries, Inc. if the required sizes are available. Refer to the skid steer manufacturer’s manual for the proper
procedures for attaching and detaching hydraulic hoses.
NOTICE
MACHINE OPERATION
TO ATTACH THE FORESTRY MULCHER:
Follow all safety, maintenance, and operation procedures in the skid steer operator’s manual, including how
to attach and disconnect implement attachments.
WARNING
!
TO DETACH THE FORESTRY MULCHER:
1. Travel the skid steer to the forestry mulcher attachment.
2. Position the attachment wedges into the locking hooks on
the universal attachment plate.
3. Engage the quick attach locks.
4. Clean the hydraulic quick couplers and attach the
hydraulic hoses to the skid steer. Consult the skid steer
manufacturer’s manual for the proper procedures.
5. Make sure to lock the couplers by twisting the sleeve at
least 1/4 of a turn after connecting. Failure to do this may
result in damage to the hydraulic components.
1. Lower the forestry mulcher attachment to the ground.
2. Do not exit the operator’s cab unless: the cutter head has
come to a complete stop, the cutter head is setting on the
ground, and the ignition key is in the operator’s possession.
3. Line up the shoulder groove on the sleeve with the detent
ball and disconnect the hydraulic hoses from the skid
steer. Consult the skid steer manufacturer’s manual for
the proper procedures.
4. Disengage the quick attach locks.
5. Back the skid steer away from the forestry mulcher
attachment.
To Next Page
Loading...