Bandit
21
Copyright 6/18
MODELS 60FM / 72FM MAINTENANCE
1. Grease both zerks on mulcher overhung load adapter every 30 hours or weekly
with 2 pumps of Mobil 1 Universal Synthetic grease, Mobil SHC 220 Synthetic
grease, Mobil AW2 Synthetic grease, or Amsoil Multi-Purpose Grease NLGI#2.
2. Lubricate steel friction areas: pivoting, hinged, sliding, & rotating areas
(i.e. pivoting hose holder, access door hinges, etc).
3. Remove mulcher head guards, wipe o excess grease, clean out debris, and
make sure the bearing grease lines are working properly.
WEEKLY CHECK LIST
Each week these checks must be made:
Each day before starting your machine these checks must be made:
1. Check the safety decals, replace if damaged.
2. Check, maintain, and service all safety equipment for proper operation.
3. Check entire machine for loose nuts, bolts, and components.
4. Check all guards to make sure they are tight and securely in place.
5. Check the condition of the cutter head.
6. Check the condition of the cutter teeth, tool holders, and attaching hardware.
7. Grease mulcher head bearings with 1 shot for every 1 hour of use.
8. Grease cylinder lug pin bushings with 1 to 2 shots (if equipped).
9. Check & adjust mulcher head belt tension, (65 ft-lbs (88 Nm) with 7/8” (22 mm) deection).
10. Check all hoses, ttings, lines, and tanks for damage and uid leaks.
11. Check around the entire machine for any foreign objects, tools, cans, saws, etc.
12. Review all safety procedures on decals, from manual, and from video.
13. Wear all applicable safety equipment: hard hat, face shield, gloves,
eye protection, ear protection, etc.
14. Make sure the forestry approved door and window on the skid steer is in good condition.
15. Make sure FOPS cab on the skid steer is in good condition.
16. Follow all daily start up and maintenance procedures for the skid steer.
17. Remember to check EVERYTHING on the checklist.
DAILY START UP & MAINTENANCE CHECK LIST
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION BOLT SIZE TORQUE (FT.-LBS.) TORQUE (NM)
Mulcher Head Tooth Bolt 3/4”-10 NC 376 509
Mulcher Head Bearing Bolt 1/2”-13 NC 118 160
Mulcher Head Bearing Set Screws 39 53
Mulcher Head Sheave Bushing “3525” 83 113
Mulcher Head Shaft Bushing 61 82
Mulcher Head Motor Sheave “3020” 83 113
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque.
Use only factory approved knives and hardware.
OK REPAIRED
OK REPAIRED
To Next Page
Loading...