PAGE 7 OF 12
4. Assembly & Disassembly
4.1 Mounting suppressor
a. Loosen the suppressor and remove it.
» Right-hand thread: turn counterclockwise
» Left-hand thread: turn clockwise.
4.2 Dismounting suppressor
a. Remove the thread protection nut from the barrel (if
present). Therefore turn the nut as follows:
» Right-hand thread: counterclockwise
» Left-hand thread: clockwise.
b. Clean the thread on the end of the barrel and make sure it is
free of dirt and damage.
c. Slide the suppressor onto the muzzle thread and tighten it
until it is hand tight on the thread.
» Right-hand thread: turn clockwise
» Left-hand thread: turn counterclockwise
b. Install the thread protection nut and tighten it by hand.
» Right-hand thread: turn clockwise
» Left-hand thread: turn counterclockwise
SAFETY ADVICE!
Unload the firearm and carry out an unloading check,
following the operating instructions for the firearm.
SAFETY ADVICE!
Unload the firearm and carry out an unloading check,
following the operating instructions for the firearm.
To Next Page
Loading...