Beoconnect Core
8
CONNECT TO EXTERNAL AUDIO SOURCES
The above illustration shows how you can add Beolab speakers to a music source. The 3.5
mm jack on Beoconnect Core can be used to connect any line-level analogue or digital
(Optical) audio source so that it will play through the connected speakers. Contact your
Bang & Olufsen retailer for the right set of cables to connect your device.
Note: if you wish to connect a turntable, a RIAA preamplier is required either built into the
turntable or externally between it and your Beoconnect Core.
To Next Page