Bang & Olufsen Beogram 3000 5901 User Manual

Details on the tonearm's mechanical and performance characteristics.

Technical details regarding the drive motor's performance.

Specifications for the built-in RIAA equalization pre-amplifier.

Details for various pick-up cartridges, including tracking force and stylus.

Explanation of fuse symbols used in circuit diagrams.

Diagram illustrating the sequence of operations for a 30cm record.

Diagram illustrating the sequence of operations for a 17cm record.

List of electrical components for the control circuit PCB.

List of electrical components for the power supply PCB.

List of electrical components for the keyboard PCB.

List of electrical components for the RIAA amplifier PCB.

List of electrical components related to the chassis module.

List of electrical components for the sliding chassis module.

Part numbers for standard 2% 1/8W resistors.

Part numbers for standard 5% 1/2W resistors.

Part numbers for standard 5% 1/4W resistors.

Part numbers for standard 5% 1/8W resistors.

List of specific parts for the floating chassis.

List of specific parts for the sliding chassis.

List of various screws, washers, and other fasteners.

Procedure for adjusting the pickup arm's horizontal movement.

Procedure for adjusting the pickup arm's vertical movement.

How to adjust and check the turntable's playback speed.

Adjusting the height of the indicator arm.

Adjusting the pickup arm's vertical position relative to the chassis.

Adjusting the pickup arm's parallelism to the platter.

Adjusting the cartridge's parallelism to the platter.

Procedure to adjust the pickup arm set-down point for 17cm records.

Adjusting the diaphragm for the photo control mechanism.

Instructions for mounting and positioning PCB 1.

How to adjust and test the muting switch.

Adjusting the manual tonearm transport mechanism.

Adjusting the tonearm lift and lower mechanism.

Procedure for adjusting and verifying playback speed.

Adjusting the height of the indicator arm on the tone arm system.

Adjusting the overall height of the tone arm.

Adjusting the tone arm to be parallel with the indicator arm.

Adjusting the cartridge's parallelism to the turntable.

Procedure to adjust the pickup arm set-down point for 17cm records.

Adjusting the diaphragm for the photo control mechanism.

Instructions for mounting and adjusting the PCB 1.

How to adjust and test the muting switch.

Instructions for mounting the wire drive mechanism.

General instructions for fitting camwheels.

Specific fitting instructions for camwheel part number 1636.

Instructions for assembling the drive cable.

Instructions for fitting curved wheels.

Specific fitting instructions for curved wheel number 1636.